» Automatic Bootstrapping

To automatically bootstrap a Nomad cluster, we must leverage another HashiCorp open source tool, Consul. Bootstrapping Nomad is easiest against an existing Consul cluster. The Nomad servers and clients will become informed of each other's existence when the Consul agent is installed and configured on each host. As an added benefit, integrating Consul with Nomad provides service and health check registration for applications which later run under Nomad.

Consul models infrastructures as datacenters and multiple Consul datacenters can be connected over the WAN so that clients can discover nodes in other datacenters. Since Nomad regions can encapsulate many datacenters, we recommend running a Consul cluster in every Nomad datacenter and connecting them over the WAN. Please refer to the Consul guide for both bootstrapping a single datacenter and connecting multiple Consul clusters over the WAN.

If a Consul agent is installed on the host prior to Nomad starting, the Nomad agent will register with Consul and discover other nodes.

For servers, we must inform the cluster how many servers we expect to have. This is required to form the initial quorum, since Nomad is unaware of how many peers to expect. For example, to form a region with three Nomad servers, you would use the following Nomad configuration file:

# /etc/nomad.d/server.hcl

data_dir = "/etc/nomad.d"

server {
  enabled          = true
  bootstrap_expect = 3
}

This configuration would be saved to disk and then run:

$ nomad agent -config=/etc/nomad.d/server.hcl

A similar configuration is available for Nomad clients:

# /etc/nomad.d/client.hcl

datacenter = "dc1"
data_dir   = "/etc/nomad.d"

client {
  enabled = true
}

The agent is started in a similar manner:

$ nomad agent -config=/etc/nomad.d/client.hcl

As you can see, the above configurations include no IP or DNS addresses between the clients and servers. This is because Nomad detected the existence of Consul and utilized service discovery to form the cluster.

» Internals

As discussed in the previous section, Nomad merges multiple configuration files together, so the -config may be specified more than once:

$ nomad agent -config=base.hcl -config=server.hcl

In addition to merging configuration on the command line, Nomad also maintains its own internal configurations (called "default configs") which include sane base defaults. One of those default configurations includes a "consul" block, which specifies sane defaults for connecting to and integrating with Consul. In essence, this configuration file resembles the following:

# You do not need to add this to your configuration file. This is an example
# that is part of Nomad's internal default configuration for Consul integration.
consul {
  # The address to the Consul agent.
  address = "127.0.0.1:8500"

  # The service name to register the server and client with Consul.
  server_service_name = "nomad"
  client_service_name = "nomad-client"

  # Enables automatically registering the services.
  auto_advertise = true

  # Enabling the server and client to bootstrap using Consul.
  server_auto_join = true
  client_auto_join = true
}

Please refer to the Consul documentation for the complete set of configuration options.